Tie a secure knot in 3 simple steps

Tie a secure knot in 3 simple steps

Steps:

  1. Hold one end of rope in each hand.
  2. Cross the right working end over then under the left standing end.
    It should look like the start of tying shoelaces. The ends should have switched hands.
  3. Now do the same action, but backwards. Cross the left working end over then under the right standing end.
  4. Pull tight and you are done.
Back to blog

Leave a comment

Please note, comments need to be approved before they are published.

  • Colour Pop Earrings

    Colour Pop Earrings

    Pick up one matt gold super duo, one cranberry seed bead. Repeat three times so you have four of each bead on the thread leaving a long tail of approx...

    Colour Pop Earrings

    Pick up one matt gold super duo, one cranberry seed bead. Repeat three times so you have four of each bead on the thread leaving a long tail of approx...

  • How to make a floating necklace

    How to make a floating necklace

    How to make a floating bracelet: Take about 50cm of steel wire and fold it in half. Attach a crimp bead at the top so you create an eye. Attach...

    How to make a floating necklace

    How to make a floating bracelet: Take about 50cm of steel wire and fold it in half. Attach a crimp bead at the top so you create an eye. Attach...

  • Anklets made easy

    Anklets made easy

    Begin by measuring your ankle. Write down the measurement, and add about four inches. Use the end cutters to cut the beading wire to this length. Put a crimp bead...

    Anklets made easy

    Begin by measuring your ankle. Write down the measurement, and add about four inches. Use the end cutters to cut the beading wire to this length. Put a crimp bead...

1 of 3